Proceedings of
Dynamic Systems and Applications, Volume-5
LaTeX template Archive (Zip)

Instruction to Authors

First Author¹ and Second Author^2
1Texas A&M University, Neural Modeling Society
College Station, TX 77843-3116
²Research Center, Clark Atlanta University,
Atlanta, GA 30314

ABSTRACT:The abstract must not exceed 200 words. Begin the abstract two lines below the address.
AMS (MOS) Subject Classification. 35K60, 35K57

 1. INTRODUCTION

Authors of contributed and invited papers are requested to e-mail, before August 31, 2007, an article (TEX file) not exceeding 8 pages of their research presentation (each additional page costs US$50.00 per page). Manuscript should be in English and typed 1.0 spaced, 6 inches width( margins 1.25 inches on left and right) and 9.5 inches deep( margins .75 on top and bottom) of 8.5X11 (or 8.5X14 ) white paper. The first page should have 1.75 inches top margin.

Manuscript submitted to the conference proceedings  has not been published previously, has not been copyrighted, is not been submitted elsewhere and the author(s) agrees that the copyright for the article will be transferred to the publisher upon acceptance of the article. A sample tex file will be mailed to you on request.

 2. SECTIONS AND SUBSECTIONS

2.1. Sections
Titles of all principal SECTIONS, ACKNOWLEDGEMENT, AND APPENDICES should be typed centered capitalized bold in the same font as the manuscript. Appendices should follow REFERENCES and should be indexed (A, B,...) or enumerated ( 1,2,...).

2.1.1 Subsections
Title of subsections should be typed bold left edge adjusted with the same font as the manuscript.

3. TEXT

Paragraphs should have 0.3 inch indent. First paragraph in a section/subsection or after expression or Figure should be typed without indent. Type all equations. Enumerate in Arabic numerals in parenthesis flush with margin. Number display equations consecutively. Reference citation should be typed in the text as follows ( Hebb, 1949; Rubner & Schulten, 1990; Ackley et al., 1985).

All acknowledgements for technical and financial support should go in the special section, which follows the text but precedes the references.

 4. PREPARATION OF CAMERA-READY ILLUSTRATIONS

Proper figure (Black & White only) preparation is essential for optimum reproduction of line drawing and photograph. Figures and Tables should be placed as part of the text and should be numbered.

 REFERENCES